Unpacking And Assembly - Powr-Flite PIRANHA PS 400 Manual De Instrucciones

PS 400 5.959-067

1.Unpacking and assembly

Owing to packaging design considerations, the unit is shipped
only partially assembled. To assemble the unit, perform the
following steps in the sequence indicated:
– Remove sweeping debris
Note: The container holds the hardware package required
for assembling the outrigger broom.
A Assembling outrigger broom. Place drive disc and broom on
broom drive shaft and secure with flat washer and hex nut.
Caution: Drive pins in the broom base must engage in drive
disc.
Installing and replacing the battery
– Remove the cross-headed screws in the unit cover.
B/C Take a firm hold of the cover and lift it off over the bars of the
push handle.
– Unscrew the battery retaining bracket and install the battery.
Attach the bracket and screw it down tight.
– Attach the red cable to the positive (+) post.
Note: Depending upon the type of battery posts, use the
enclosed adapters.
Before connecting negative battery cable (-), replace the unit
cover.
D Replacing unit cover
Note: Ventilator wheel must not touch any components (i.e.,
cables), and cables must not project from unit.
E On the factory-packed unit, the push handle is folded down.
Mount securely, using supplied nuts and bolts.
Caution: After mounting the push handle, make
sure that the unit main switch is in the OFF
position (white marking is visible).
F Open the battery compartment cover. Connect battery cables
to battery posts.
Note: red
black
– Charge the battery (see section, "Important battery
information", above).
2.Operation
A Switch the unit ON by pressing the unit main
switch. Press once
Press twice
Note: The unit main switch features a built-in overload
protection. If the switch pops out, the most likely reason is
excessive electrical load. Before re-activating the unit, wait
at least 3 minutes and remove the cause of the overload,
i.e., string or twine wrapped around the brush roller, or
similar obstacles.
B Pull the drive lever. Unit moves forward.
Note: When first using the unit after unpacking and assembly,
pull drive lever slowly and observe starting speed.
= positive post (+)
= negative post (–)
– motor ON
– motor OFF
ENGLISH
5