Specific Safety Rules - RODCRAFT MBX - RC7091 Manual De Instrucciones

GB Operating Instructions

Specific Safety Rules

To operate this tool safely and effectively, you must read and follow the operating and
safety instructions completely.
Use this tool with a MBX belt only. This tool is a specialized tool for MBX application and must not be used with other
accessories.
Always wear protective goggles, facemask, gloves, and suitable protective clothing! Do not wear loose chains, jewellery,
loose cuffs, or other loose clothing that could become entangled in the tool.
Disconnect tool from air supply before changing or inspecting a MBX belt. Do not service the tool while the tool is
connected to an air supply.
After changing the MBX belt, check the adaptor to confirm correct assembly.
Always release the throttle lever before connecting the air supply.
Never use this pneumatic tool at air pressure above 90 PSI (6 bar) at tool inlet. This is an ungoverned tool and its free
speed will increase in proportion to any increase in air pressure above 90 PSI. You must use a reliable automatic air
pressure regulator to control the air pressure supplied to this tool within the suitable range.
Periodically monitor air pressure.
Always place the „MBX" elliptic (oval) label side up when placing the tool on a worktable or the floor.
When not in use, disconnect the tool from the air supply and store in a safe, secure place, to prevent accidental or
unauthorized use when the authorized operator is not present.
When using this tool, always hold both the tool body and the vertical grip.
To avoid accidents, always keep the tool body and the vertical grip dry, clean, and free of oil and grease, so that the
tool does not become slippery.
Keep visitors at a safe distance and out of diametric line with MBX belt.
Never allow children, unauthorized persons, or persons without protective goggles and other protective gear to enter
the work area.
Never allow the MBX to come into contact with soft objects, human beings or animals.
Never touch the MBX belt when the tool is running.
Use the MBX belt in the proper direction.
Do not use this tool in the presence of flammable liquids and gases. MBX bristles can cause sparks when applied to
hard surfaces.
Never operate this or any other tool when you are tired.
Handle the tool safely and gently. Never carry the tool with your finger on the throttle lever while the tool is connect-
ed to an air supply.
Never carry the tool by the air hose. Protect the air hose from heat and sharp edges.
If a sudden change occurs in the feel (vibration level) or sound (pitch) of the tool, turn off the tool immediately and
inspect the MBX belt for damage.
Stay Alert. Watch what you are doing. Use common sense and prevent injuries.
12
MBX System Pneumatic