Uline H-1225 Manual De Instrucciones página 4

3
3
Figure 4
Figure 5
Figure 6
PAGE 4 OF 12
ASSEMBLY CONTINUED
7
8
1-800-295-5510
uline.com
9. Insert legs (3) into the corner between the bottom
and the side. Bolt the leg to the side using two bolts
and nuts per leg. (See Figure 4)
10. Place door and frame assembly (7 & 8) over the
locker body. Make certain the body sides are inside
the frame and not between the frames. Attach
top to frame header and bottom to frame sill (one
bolt each). Finish by attaching the door and frame
assembly to the sides of the locker body (bolts will
be shared with the door and frame on either side of
them). (See Figure 5) If joining a 3-wide unit beside
another unit see JOINING UNITS TOGETHER below.
11. Stand unit upright and place in desired location.
If joining units together, remove temporary bolts in
frames and bolt adjacent units together through
frames. Check and tighten all permanent bolts.
NOTE: If the temporary bolts are not removed
before the frames are joined side by side, the
frames will have a 1/8" gap between them.
JOINING UNITS TOGETHER
1. If joining a 3-wide unit beside another unit,
temporarily install a bolt and nut into the third and
sixth holes down from the top of the outer frame(s)
that will be joined to the adjacent locker frame(s).
(See Figure 6) The center locker frame can be
bolted complete.
SECURING UNITS
1. Anchor units to wall or floor. Units are not intended
to stand free and may topple if not secured. (Units
standing back to back should be bolted together.)
CAUTION! Care must be taken to assure
that lockers are set plumb and true before
anchoring.
2. If units are not pre-numbered, an optional number
plate (11) may be attached with two #6 x 5/16 drive
screws or push plugs (12).
0821 IH-1225