Accessories; Communication; Interface Commands - OHAUS PR Serie Manual De Instrucciones

PR Series Balance
9.3

Accessories

DESCRIPTION
Auxiliary Display AD7-RS
Security Device
RS232 Cable 25 pin
RS232 Cable 9 pin
Dust Cover
In-use Cover
Printer SF40A
Power Adapter for Balance
9.4

Communication

9.4.1 Interface Commands

Commands listed in the following table will be acknowledged by the balance.
Command Function
IP Immediate Print of displayed weight (stable or unstable).
P Print displayed weight (stable or unstable).
CP Continuous Print.
SP Print on Stability.
SLP Set Auto Print to On Stability, allow non-zero displayed weight be printed.
SLZP Set Auto Print to On Stability, allow both stable non-zero weight and stable zero reading to be
printed.
xP Set Auto Print to Interval Print, x = print interval (1-3600 sec), 0P disable the interval Print
0P 0P disable interval print, continuous print or print on stability
H Enter Print Header Lines, the format is: H x "header string".
Where x = line number 1 to 3, "header string" can be up to 24 alphanumeric characters.
If no string in the command, "H x" will read the stored header x.
Z Same as pressing Zero Key.
T Same as pressing Tare Key.
xT*** Establish a preset Tare value in displayed unit. x = preset tare value. Sending 0T clears tare (if
allowed).
PT Prints Tare weight stored in memory.
PM Print current application mode (weighing mode).
xM Set current application mode to x. x depends on applications
1 – Weigh
2 – Count
3 – Percent
M Scroll to the next enabled mode.
ON Brings out of Standby
OFF Goes to Standby.
C Begin Span Calibration
IC Begin Internal Calibration.
PART NUMBER
30472064
80850043
80500524
80500525
30093334
30372547
30064202 (EU); 30064203 (AM)
46001724
EN-41