Suntec Wellness Klimatronic Night Sun Manual De Instrucciones página 13

• Warning: In order to avoid overheating, do
not cover the heater!
Installation
Before installing your appliance, you must disconnect the electrical supply at the circuit
breaker.
-
Insert the lower post assembly (11) into the base assembly (16) and then fix it tightly with the 4
M6X30 screws (15). Then insert the first clamp (12) into the lower post (11) (see fig.1).
-
Join the Lower Post Assembly (11) and the Middle Post (9) together with 3 M5X6 screws (10) (see
fig.2). Insert the second clamp to the Middle Post.
-
Join the Upper Post Assembly (7) and the Middle Post (9) together with 3 M5X6 screws (8) (see
fig.3). Insert the third smaller clamp to the Upper Post.
-
Join the Heating Element Assembly (1) with the Upper Post Assembly (7), then fix them tightly by
rotating the knob and put the power cord (13) into the clamps (12) (see fig.4).
-
The Heating Element Assembly can adjust its angle between 0º and 45º depending on your needs
(see fig.5).
Operation
The appliance is switched on by means of the pull switch (5). The slight vibration noticeable when the
appliance is switched on will stop after a few seconds.
Output
-
Position 0: Stop
-Position 1: 650W (normal power)
-Position 2: 1300W (intermediate power)
-Position 3: 2000W (full power)
Maintance
Your appliance dose not requires any particular maintenance. However, in the event of a malfunction,
please consult an Approved Service Center.
In case of complaint
•
You can claim the device within 24 months from date of purchase (receipt).
•
A free replacement or repair will be excluded from prior improper product handling.
•
Defects in wear parts, consumables, as well as cleaning, maintenance or replacement of said
parts are therefore with costs.
•
If you want to make a complaint, please bring the entire device in its original packaging and with
proof of purchase to your dealer. For a timely and convenient service register, visit our website