Tabla de contenido
Publicidad
EN
Important assembling advice: Mirror
Suitable for renovation work and new construction
The Mirror should only be installed by specialist companies in compliance with the building regulations. To
achieve the best possible result, please read the installation guide carefully. If you have any questions, please
consult your supplier.
Attention!
Before commencing installation, please check the
▪
package contents for completeness and possible
damage. In the event of any damage or missing items,
please contact your supplier and do not install the mirror.
Any damage must be reported immediately. Any claim
▪
for damage will not be accepted after assembly or
installation.
The corners and edges of the mirror glass are extremely
▪
fragile; the slightest impact can lead to damage. Always
place the mirror on a soft surface. Placing the mirror on a
hard surface such as tiles can directly result in damage.
Assembly must always be carried out by two people to
▪
prevent damage.
All electrical components are connected with flexible
▪
cables. The mirror can only be connected to a 230VAC
supply and the cable must be wired to a suitable wall
outlet. Please note the safety instructions below.
The mirror is only suitable for indoor use in zone 2&3 in
▪
the bathroom (IP44 certified).
Strict compliance with the user manual is required in
▪
order to maintain the warranty and liability conditions.
The instructions as detailed in our sales and delivery
terms must be strictly adhered to
The exact specification of your mirror will depend on
▪
your order.
Safety instructions:
The product must be installed in accordance with
▪
applicable national and international laws and
regulations. Installation of the mirror must be carried
out by a suitably qualified professional/professional
electrician.
Never work on an electrical installation that still has
▪
voltage. Switch off the electricity supply by turning off
the main or group switch. Check with a proper voltage
finder whether you have switched off the correct
group(s). Never work on an electrical installation that still
has voltage. Switch off the electricity supply by turning
off the main or group switch. Check with a proper
voltage finder whether you have switched off the correct
Typing and printing errors reserved. Easy Sanitary Solutions BV excludes all liability for any damages whatsoever associated with the use and/or
the installation of the drain. Easy Sanitary Solutions BV a priori excludes any liability whatsoever.
group(s).
Only parts or replacement parts supplied by the
▪
manufacturer must be used. The use of parts supplied by
any third party or parties will void any warranty or liability.
The Mirror must not be connected to a dimmer or any
▪
other voltage regulator.
Do not install or use the Mirror in the vicinity of any heat
▪
sources or flammable materials.
Once installed, supply the Mirror with power by
▪
switching on the main or group switch again. The Mirror
is suitable only for a mains supply of 230VAC, 50Hz.
The LEDs and the LED driver (if fitted) are sealed units.
▪
For safety and to preserve the warranty, these must not
be opened.
Mirror
11
Publicidad
Tabla de contenido
