Important Assembling Advice - ESS Easy Drain Fixt 30 Consejo Para La Instalación

Important assembling advice: Fixt
Suitable for renovation work and new construction
The shower drain should only be installed by specialist companies in compliance with the building regulations. To
achieve the best possible result, please carefully read the installation guide. If you have any questions, please consult
your supplier.
▪
Please check the content of the package for completeness and
integrity before proceeding with the assembly. Do not install
the channel drain if any deviations are noted. Should this be
the case, please consult your supplier.
▪ Prior to the assembly, the assembling advice and its special
characteristics should be discussed with the tiler. After
the assembly, please provide the tiler with the complete
assembling advice.
▪
If the shower drain is used for several showers, please check
to make sure that the drainage capacity is sufficient. If you are
unsure, please consult the supplier for advice.
▪ We recommend taping the drain opening of the shower
drain prior to the assembly to prevent construction debris
from getting into the drainage pipe. To prevent damage to
the tile frame, it should be kept in the package until the final
installation by the tiler.
▪
Assemble the height adjustable supports and level the shower
drain all around. Mount the earthing on one of the anchoring
clips.
▪ Install the sewage system in compliance with the standards.
Note: ensure that the sewage system is well ventilated and
that the gradient is sufficient.
▪
Check the shower drainage system and the sewer system
connections for tightness.
▪ The drain must be fully lined and sealed with floor pavement
to the upper edge of the flange to prevent hollow spaces.
▪
The seal is applied in compliance with the "generally
accepted engineering standards" according to the ZDB
(Central Association of the German Construction Industry)
code of practice 1/2010 "sealing compounds". If alternative
seals are used, please read the manufacturer's product
information.
▪ When tiles are being fitted, the gradient of the tiles (min. 2%
per linear metre) in the shower must always be towards the
drain. The tiles should be laid level or 1 mm higher than the
top edge of the tile frame to ensure good drainage toward the
shower drain. Note: the requirements with regard to the floor
gradient may be different for walk-in showers with glass walls.
Please consult your supplier in this respect.
▪
Once the tiles have been fitted, the joint between the tiled
floor and the drain should be permanently sealed with an
elastic sealant (maintenance joint). The adhesion surfaces
Typing and printing errors reserved. Easy Sanitary Solutions BV excludes all liability for any damages whatsoever associated with the use and/or the installation
10 Fixt
of the drain. Easy Sanitary Solutions BV a priori excludes any liability whatsoever.
UK
should be free of mortar, adhesive and other adhesion-
reducing materials. See drawing on page 7.
▪ The shower drain system is only intended for use with waste
water common in households. Do not use other fluids as well
as cleaning agents with the potential to damage sanitary
equipment, drainage equipment and raw materials.
▪
If the shower drain is used for other purposes (e.g. swimming
pools), where it may come in contact with aggressive cleaning
agents or corrosive substances such as salt or chlorine, please
consult your supplier.
▪ Compliance with this installation advice is required for any
warranty claims based on our sale and delivery terms.
Caution !
▪ Tile cleaning products often contain aggressive chemicals that
are abrasive in nature and may damage the drain. Please
ensure that the drain is thoroughly flushed after using any tile
and grout cleaning products.