Installation Instructions - Westfalia 342 076 Instrucciones De Instalación Y Funcionamiento

Installation Instructions:

1.) Hold angle brackets "2" under longitudinal members of vehicle and drill (17 mm dia.) through
longitudinal member at "a". Lay counter-shackles "3" in longitudinal members and bolt angle
brackets "2" to longitudinal members and counter-shackles "3".
If there is a Frame cross member at the point where drill holes are to be bored, the Fishplater
'6' must be placed between the Frame side member and the Frame cross member.
2.) Push clamps "4" onto cross pipe "1" and align desired width so that holes "b" are located
41.5 mm to left and right of centre.
Dimension 1100 mm (see drawing) may not be exceeded.
Pipe ends may be cut off if necessary. Make sure that at least 50 mm is left beyond clamps.
Then deburr cut areas.
3.) Bolt cross pipe "1" onto angle brackets "2" at "d" at desired height with clamps "4".
If ends of angle bracket "2" protrude at bottom, then ends may be cut off. Then deburr cut
areas.
4.) Drill through lower wall of cross pipe "1" (11 mm dia.) at "e".
Push shackles "5" into pipe ends and bolt to cross pipe "1" at "e".
5.) Screw electrical socket bracket "7" onto bracket at "f".
6.) Tighten all bolts and nuts evenly.
Tightening torques:
Subject to change.
M 10x30
M 10x35
M 10x50
M 10x65
M 16x50 170 Nm
M 16x55 170 Nm
40 Nm (property class 8.8)
55 Nm (property class 10.9)
55 Nm (property class 10.9)
55 Nm (property class 10.9)
(property class 8.8)
(property class 8.8)
25