SPIT 1625 Instrucciones Para El Manejo página 11

GB
exchanging the paper filter bag
Carefully pull the flange from the suction connections and close the flange.
Turn on the motor before putting down to ensure that any falling suspended dust
can be suctioned.
Dispose of the vacuumed material as per the statutory regulations.
4
Plastic emptying bag
Only the M and H vacuum cleaners with the
special tanks and rotary valve in the suction
3
opening AC 1625 M is suited for using plastic
emptying bags.
Turn the rotary valve with the round label
upwards in the suction opening ● 4.
2
1
operating the slide valve:
Push the slide valve from inside to the outside 1, turn by 180° 2 (see marking 4)
and press from outside through the suction pipes to the inside again 3.
Push the flange over the suction pipes, place the opening of the bag over the edge
of the tank.
exchanging the plastic emptying bag
Detach the suction hose, close the suction opening ⑧ with a plug (Pos. ⑧a).
Remove the top section ①. Switch on the motor before placing on the ground so
that any falling dust can also be suctioned. Close the emptying bag with a closing
band.
Pull the flange carefully in front of the suction opening and close tight. Dispose of
the contents in accordance with the statutory provisions.
cleaning
Clean the tank and accessories with water.
Wipe the top section ① with a damp cloth.
Allow the tank and the accessories to dry.
Filter cassettes with air pressure do not clean
11