Care And Maintenance - AEG Perfect DB 50 Serie Instrucciones Para El Uso

822 949 308 DB_5020_5040.book Seite 14 Mittwoch, 26. Oktober 2005 4:58 16
g

Care and Maintenance

Descaling
When using tap water for steaming,
limescale is deposited in the steam
chamber; heavy deposits reduce the
quantity of steam produced.
For descaling use lukewarm water and
vinegar essence – mixing ratio 1:1.
Pour the mixture into the appliance
when cold and disconnected from the
mains (Figure 3).
Proprietary brands of descaler are
too aggressive and must not be used!
0 Unplug from the mains.
0 Set the steam selector (Figure 1/F) to
position "0" (Figure 4/A).
0 Fill the water reservoir (Figure 1/O) to
the "MAX" mark.
0 Set the temperature selector
(Figure 1/N) to "max.".
0 Insert the plug into the socket.
0 Wait until the power indicator
(Figure 1/J) goes out.
0 Remove the plug from the mains.
0 Place the appliance horizontally on an
iron rest or plate (Figure 5).
0 Set the steam selector (Figure 1/F) to
position "4" (Figure 4/B) and allow all
the mixture to flow through.
0 Afterwards repeat the procedure using
clear water and then heat the steam
iron briefly to allow the steam cham-
bers to dry. Your steam iron is now
ready for use again.
As a precaution we recommend des-
caling every three months.
14
What to do, if ...
• no "steam" appears when using on a
steam setting?
– In warm, dry air (during the winter),
reduced amounts of vapour are nor-
mal because it is absorbed by the dry
air before condensing.
– Emptying the filled water reservoir
can wash out fluff. Remove the
mains cord and tip the filled
appliance forwards at an angle
(Figure 7) so that the water can run
out of the filling aperture.
• drops of water are coming out of the
steam exit holes?
– Do not set the steam selector to
position "1" or higher until the tem-
perature for steam ironing has been
reached. If the temperature has been
set too low for steam ironing
increase the setting.
• stains appear on the washing while
ironing?
– Clean the steam iron. Rub the sole-
plate while still warm with a mixture
of water and vinegar or with a non-
abrasive cleaning agent.
– When dry ironing fluff can enter the
steam chambers and carbonise. This
can lead to stains as the water pas-
ses through. Therefore also clean the
inside of the water reservoir. Fill it
with water and gently shake the
steam iron. Then pour the water out.
• the soleplate is rough or furred?
– The iron temperature was set too
high.
– Select the correct ironing tempera-
ture for the fabric (see ironing
table).