Dörr HC 2000 Manual De Instrucciones página 4

English
I. Names of Parts
1. Housing
2. Belt Buckle
3. Strap Lock
4. Indicator Panel: Battery Level Indicator;
Status Indicator (STATUS);
Charging Indicator (CHARGE).
5. Touch Button
6. Multifunctional Socket
7. Flash Power Connector Cable
8. Heat Dissipation Hole
9. AC Charger
10. Car Charger
11. Carrying strap
11
II. Operations
Start-up
• Select a connector cable that is compatible with your product.
• Connect the power plug of the connector cable to the multifunctional socket of the power pack.
• Insert the terminal of the connector cable into the flash.
• Press the touch button, the LED battery level indicator and the working indicator will turn on,
indicating readiness of the power pack.
Note: If this power pack is used for a flash, the battery in the flash shall have built-in
batteries with sufficient power.
Power-off
• Turn off the power pack by pressing the touch button;
• Turn off the power pack by directly unplugging the connector cable from the power pack.
III. Battery Charging
• Insert one end of the charger into an AC socket (100-240V), or, when using a car charger into the cigarette lighter
port on the vehicle: Insert the other end into the multifunctional socket of the power pack. The charging indicator
gets on and the LED battery level indicator begins to flicker, indicating that the battery is being charged.
• LED1, LED2, LED3 and LED4 remain flickering during charging and remain on after the battery is fully charged.
• This power pack product uses a multifunctional socket for power output and battery charging.
www.doerrfoto.de
DÖRR Powerpack HC 2000
8
10
9
DÖRR GmbH Fotomarketing • Postfach 1280 • 89202 Neu-Ulm/Germany
DÖRR Powerpack HC 2000
IV. Instructions for Relevant Statuses of the Power Pack
• Power-off status: There is no LED indication, and no power output from the multifunctional socket; energy
consumption of the entire unit is extremely low; the loss of battery level can be ignored.
• Test status: When the connector cable is not inserted into the multifunctional socket, press the touch button
to enter the test mode; at this moment there is only battery level indication. Press the touch button again or
wait for 3 seconds to return to the power-off status.
• Working status: insert the connector cable into the multifunctional socket; press the touch button to enter the
working status; at this moment the LED indicator gets on. Press the touch button or unplug the connector
cable from the multifunctional socket to enter the power-off status.
Automatic Power-off Function: The unit has automatic power-off function after working for twelve hours,
• Charging status: when the multifunctional socket of the device is connected with the charger, it enters the charging
status when the charger is powered on; at this moment the charging indicator gets on and the battery level
indicator flickers. When all battery level indicators stop flickering and turn on, the battery has been charged full.
V. LED Indicators
1. Battery level indicators: LED1, LED2, LED3, LED4
3
LED
Battery Level
Weak
Low
Middle
To be full
Full
• Please timely charge the battery according to the indication of the LEDs.
• When LED1 flickers, the device will disable power output; the battery needs immediate charging before the can
be used again.
2. Status indicator: LED5
• When used for a flash
The LED5 is off during flash charging, and will get on when the flash is charged full.
• If LED5 flickers, it indicates that the flash has been overused; in case of excessively high temperature inside
the power pack, the overheat protection will be enabled with the power output suspended; please wait for
over 10 minutes before using it again.
3. Charging indicator: LED6
• It is off if no battery is being charged.
• It is always on during charging or when the battery has been fully charged.
• It will flicker if the battery is not charged full after 4 hours' continuous charging, which indicates an overused
or faulty battery. In this case, please replace the battery immediately.
VI. Operation Time
Using the DÖRR HC2000 power pack, it takes only one second to charge Canon 580EX II, Nikon SB900 and Sony
F58AM flashes at the maximum power, and 500 times of flashes in full brightness is supported.
DÖRR GmbH Fotomarketing • Postfach 1280 • 89202 Neu-Ulm/Germany
in case shutdown is forgotten, leading to long time power consumption.
LED 1 LED 2 LED 3
Flicker OFF OFF
ON OFF OFF
ON ON OFF
ON ON ON
ON ON ON
English
LED 4
OFF
OFF
OFF
OFF
ON
www.doerrfoto.de