Ring; O-Ring - ORBILOC DOG DUAL Guía Rápida

ORBILOC SERVICE KIT
The Orbiloc Service Kit makes maintaining
your Orbiloc Dog Dual quick and easy.
The Orbiloc Service Kit contains a Lithium
Battery Pack (6) (2 x CR2032) and an O-ring
(3) lubricated with silicone.
CHANGE BATTERY AND MAINTAIN
Rinse your Light (refer to page 6). Unscrew the
Base (7) of the Orbiloc Dog Dual and remove
the old Battery Pack (6) and O-ring (3) and
return it to your local municipal collection point.
Clean the O-ring Groove of the Lens (1).
Rub and thereby apply Silicone to the entire
surface of the O-ring (3) before removing it
from the zip-bag. Make sure there are not
visible lumps of grease – It is possible to
over-grease the O-ring (3)! Install the new
O-ring (3) in the designated O-ring Groove
on the Lens (1). Make sure to clean your
fingers before proceeding.
+
Place the new Battery Pack (6) with the
symbol facing down in the Base (7) of the
Light. Screw the Lens (1) and Base (7) of the
Orbiloc Dog Dual together again.
NOTE: Should the Light be in and out of water
often, the O-ring (3) should be lubricated
with silicone and the Light should be rinsed
after each time (please refer to page 6).