Kohler REVIVAL K-2001 Instrucciones De Instalación página 6

Mark the centers of the anchoring holes for the lavatory
and mark a line at the front of the pedestal.
Remove the lavatory and pedestal.
Measure from the front of the bottom of the pedestal to the
mounting hole. For K-2000-* – use front hole; see "Y". For
K-2002-* – use center hole; see "X". Compare this
dimension to the distance between the line on the floor
and the location of the mounting hole previously marked.
Relocate mounting hole if required.
Drill holes for 5/16" hanger bolts for securing lavatory and
pedestal. Other fastening devices of sufficient size and
strength may also be used.
Mount the hanger bolts to the wall and floor leaving
approximately 1-1/4" (3.2cm) of bolt exposed.
Before installing the lavatory, attach the faucet and drain
fittings.
RECOMMENDATION: Attach valve bodies before spout.
Make sure that the 1-1/4" (3.2cm) tailpiece is installed to
the drain body. Attach U portion of P-trap to tailpiece.
Refer to faucet and drain manufacturer's instructions.
NOTE: Do not fully tighten the slip-joint connection.
Set the pedestal mounting hole over the floor-mounted
hanger bolt. The purpose of this hanger bolt is to prevent
the pedestal from moving sideways – the pedestal does
not need to be secured with a nut.
Set the lavatory back into the mounting position and level.
Install cap nuts and washers and secure the lavatory to
the wall. Carefully turn nuts until contact is made with the
vitreous china.
CAUTION: Do not overtighten as breakage may
result.
Connect and tighten trap.
Connect hot and cold supplies to faucet.
INSTALLATION K-2001-*, K-6860:
Rough-in the supplies and drain piping according to the
roughing-in dimensions illustrated on Page 4.
NOTE: Control stop handle when in full open position
must not extend more than 7" (17.8cm) from finished wall.
Install sufficient backing behind the finished wall for
anchoring devices.
A
1007269-2-
FINISHED WALL
K-2002
12-3/16"
(31cm)
X
K-2002-*
WASHER
6
K-2000
15-1/8"
(38.4cm)
PEDESTAL
BASE
Y
K-2000-*
Fig. #7
LAVATORY
CAP NUT
Fig. #8
Kohler Co., Kohler, WI, U.S.A.