Kohler ANATOLE K-2099 Instrucciones De Instalación
Kohler ANATOLE K-2099 Instrucciones De Instalación

Kohler ANATOLE K-2099 Instrucciones De Instalación

Lavabo de porcelana vítrea con pedestal
Ocultar thumbs Ver también para ANATOLE K-2099:

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

R
BEFORE YOU BEGIN
NOTES
S
Observe all local plumbing and
building codes.
S
Prior to installation, unpack the
new lavatory and inspect it for
damage. Return the lavatory to its
protective carton until you are
ready to install it.
ROUGHING-IN
(S) Supply 10" (25.4cm) (Based on 12"
(30.5cm) riser which may require
cutting).
(T) Pop-up drain typically 14-1/8"
(35.9cm).
K-2099-4
15" (38.1cm)
FINISHED
WALL
4" (10.2cm)
2-7/8"
(7.3cm)
18-1/4"
(46.4cm)
21-3/4" (55.2cm)
11-3/8" (28.9cm)
(S)
(T)
3/8" HOT
4" (10.2cm)
A
1011304-2-
ANATOLE
VITREOUS CHINA
PEDESTAL LAVATORY
S
These instructions are for installing
the lavatory to wood frame
construction. For other
installations, supply suitable
bracing and fastening devices of
sufficient size and strength.
S
The walls and floor must be
square, plumb, and level.
Fixture dimensions are nominal and
conform to tolerances in ASME Standard
A112.19.2M.
K-2099-8
4" (10.2cm)
2-7/8"
(7.3cm)
7-1/4"
8"
(18.4cm)
(20.3cm)
K-2099-1
2-7/8"
(7.3cm)
1/2" D. MOUNTING HOLE
IN PEDESTAL
3-1/2"
8-1/2"
(8.9cm)
(21.6cm)
1/2" D.
31-7/8"
ANCHOR
(81cm)
HOLES
FINISHED
3/8" COLD
FLOOR
1-1/4" OUTLET
Español, Página 5
Français, Page 9
K-2099
4" (10.2cm)
FINISHED
WALL
6-1/8"
(15.6cm)
E2001 Kohler Co.
1 1

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Kohler ANATOLE K-2099

  • Página 1 1/2” D. MOUNTING HOLE 6-1/8” 21-3/4” (55.2cm) (15.6cm) IN PEDESTAL 11-3/8” (28.9cm) 3-1/2” 8-1/2” (8.9cm) (21.6cm) 1/2” D. 31-7/8” ANCHOR (81cm) HOLES 3/8” HOT FINISHED 3/8” COLD FLOOR 4” (10.2cm) 1-1/4” OUTLET Español, Página 5 E2001 Kohler Co. 1011304-2- Français, Page 9...
  • Página 2: Tools And Materials Required

    Mark the center of each anchoring hole on the wall, and mark the floor through the hole in the pedestal bottom. Carefully remove the lavatory from the pedestal. Then move the pedestal from the area. 1011304-2- Kohler Co., Kohler, WI U.S.A.
  • Página 3 Do not overtighten the cap Pedestal nuts. Overtightening may cause damage to the product. Lavatory Connect and tighten the trap to drain. Connect the hot and cold Cap Nut water supplies to the faucet. Washer 1011304-2- Kohler Co., Kohler, WI U.S.A.
  • Página 4: Care And Cleaning

    First review the installation instructions to ensure correct installation. For additional assistance in the USA, call our Customer Service Department for direct help. You may also contact us at our web site listed below. Call 1-800-4-KOHLER within the U.S. Call 001-877-680-1310 within Mexico Call 1-800-964-5590 within Canada www.kohler.com...
  • Página 5: Diagrama De Instalación

    DE DI M. EN EL (15,6cm) 11-3/8” (28,9cm) PEDESTAL 3-1/2” 8-1/2” (8,9cm) (21,6cm) HOYOS DEL 31-7/8” SUJETADOR DE (81cm) 1/2” DE DI M. 3/8” CALIENTE PISO 3/8” FRÍA ACABADO 4” (10,2cm) SALIDA DE 1-1/4” 1011304-2- Kohler Co., Kohler, WI U.S.A.
  • Página 6: Herramientas Ymateriales Requeridos

    Marque el centro de cada orificio de los sujetadores en la pared y marque el piso a través del orificio en el fondo del pedestal. Con cuidado, remueva el lavabo del pedestal. Luego, remueva el pedestal de su posición. 1011304-2- Kohler Co., Kohler, WI U.S.A.
  • Página 7 No fije demasiado los Pedestal tapones roscados. El asegurar en exceso puede dañar el producto. Lavabo Conecte y asegure el sifón al drenaje. Conecte los suministros Tapón del agua fría y caliente al grifo. roscado Arandela 1011304-2- Kohler Co., Kohler, WI U.S.A.
  • Página 8: Cuidado Y Limpieza

    Si no logra solucionar el problema, llame al Departamento de Atención al Cliente para obtener asistencia directa. También puede localizarnos en la página web escrita abajo. Llame al 1-800-4-KOHLER (En los Estados Unidos) Llame al 001-877-680-1310 (En México) Llame al 1-800-964-5590 (En Canadá) www.kohler.com...
  • Página 9: Avant De Commencer

    TROU DE FIXATION 6-1/8po 21-3/4po (55,2cm) DE 1/2 PO DIA. (15,6cm) DANS LA COLONNE 11-3/8po (28,9cm) 3-1/2po 8-1/2po (8,9cm) (21,6cm) 31-7/8po 1/2po D. TROUS (81cm) D’ANCRAGE 3/8po CHAUD PLANCHER 3/8po FROID FINI 4po (10,2cm) SORTIE 1-1/4po 1011304-2- Kohler Co., Kohler, WI U.S.A.
  • Página 10: Outils Et Matériaux Requis

    Marquer le centre de chaque trou d’ancrage sur le mur et marquer le plancher à travers l’ouverture du bas de la colonne. Enlever le lavabo du dessus de la colonne. Retirer la colonne de la zone de travail. 1011304-2- Kohler Co., Kohler, WI U.S.A.
  • Página 11 Colonne Ne pas trop serrer les écrous borgnes. Le serrage excessif peut Lavabo endommager le produit. Raccorder le siphon à l’évacuation Ecrou borgne et serrer. Raccorder les robinets Rondelle d’arrivée d’eau chaude et froide. 1011304-2- Kohler Co., Kohler, WI U.S.A.
  • Página 12: Entretien Et Nettoyage

    Revoir d’abord la notice d’installation pour s’assurer d’une installation correcte. Pour toute assistance additionnelle, contactez notre département de service à la clientèle. Vous pouvez aussi nous joindre sur notre site Web à l’adresse donnée ci-dessous. Aux É.-U., composer le 1-800-4-KOHLER Au Mexique, composer le 001-877-680-1310 Au Canada, composer le 1-800-964-5590 www.kohler.com...

Tabla de contenido