18
Caroslide
Mounting underneath the Turnout / Turnin
Modify, alternatively remove the rear cover of the Turnout.
Countersink the holes in the mounting bracket to use for mounting the bracket legs.
Mount the Caroslide between the Turnout and its mounting bracket by first remov-
ing the four M8 nuts (A) from the underside of Caroslide.
Then drive back and forth to be able to reach the screws. Fix the four M8 screws in
the (M8) drilled 330 mm cc holes on the Turnout mounting bracket. Drive Caroslide
backwards. Remove the upper M8 nuts.
If it is a Turnout 2E bend down the stopper (B) on the opposite side from where the
Caroslide motor is placed, to allow free passage for the Turnout motor. Alternatively,
place a 5 mm spacer between Turnout 2E and Caroslide.
Screw the fout remaining M8 screws in the Turnout.
The wiring diagram is found on page last page.