Installing The Battery - Unitech PA600 Guía De Referencia Rápida

Installing the Battery

1
Open the battery compartment by pushing the latch in the direction of the
arrow and lifting up (A). Turn the Backup Battery Switch on (B).
2
Position the battery pack,
making sure the battery
contacts are aligned with
the contacts in the com-
partment and the battery
is placed on top of the
plastic tab, as shown in
the following illustration.
3
Slide the battery pack
into the battery bay
while simultaneously
pulling the plastic tab
and battery hook until
the battery clicks into
place.
4
Replace the battery compartment cover.
Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
A
Compartment contacts
Plastic battery tab
Battery hook
The battery compartment is displayed:
Backup Battery
Switch
B
Plastic tab
Battery hook