Neriox 109398 Instrucciones De Uso página 3

3
109398
WORKSHOP CALIPER DIGITAL
Operating instructions
1
2
Legend:
1. Measurement surfaces for outside measurement
2. Measurement surfaces for inside measurement
3. LCD display
4. OFF/ON key for activation and deactivation
5. ZERO key for resetting display to zero
6. mm/inch key, mm/inch conversion
7. Measuring rail
8. Locking screw
9. Battery compartmentacc
Safety-relevant information
• Use caliper at permissible temperature only
• rotect caliper (specifically the display unit) against liquids
and moisture
• Protect calwiper against mechanical damage
• Properly dispose of caliper
Repair
If the instrument is defective, please contact our
service centre → Servicecenter@brw.ch
Brütsch/Rüegger Werkzeuge AG, Heinrich Stutz-Strasse 20, Postfach, CH-8902 Urdorf, Tel. +41 44 736 63 63, Fax +41 44 736 63 00, www.neriox.tools, sales@brw.ch
3 8 6
5
4
1
9
7
Specification
Measurement range: 300 mm
Resolution: 0.01 mm
Operating temperature: 0...40°
Energy: Silver oxide battery SR44 (357/303) / 1.55 V
Properties
LCD display
Power ON/OFF
mm/inch conversion
Resetting to zero from any position
Mise à zéro dans n'importe quelle position
Operation:
Activation/Deactivation – briefly press OFF/ON key
Resetting display to zero – briefly press ZERO key
mm/inch conversion – briefly press mm/inch key
Instructions for care:
Keep the measurement rail clean. Cleaning agents and cleaning cloths can be used
for cleaning the surfaces;
apply a little machine oil to metal parts. Do not use petrol, acetone or isopropanol
for cleaning under any circumstances. Remove the battery if the instrument is not
going to be used for an extended period.