HAEGER FC-326.005A Instrucciones De Uso página 9

3. If using an optional light fitting, ensure the glass is properly fitted and / or
the screws holding the glass are firm.
4. If a solid-state speed control has been fitted this can cause noises in the
motor do not use these controls.
5. Allow at least 24 hours for the fan to settle, as many noises will go away.
Each blade set is weighed and is a complete set, if installing more than
one fan do not mix the blades as this can cause wobble.
The fan oscillates
1. Check the blades are securely fastened to the holders.
2. Check the blade holders are tight on the motor.
3. Ensure the mounting bracket is properly screws to the ceiling.
4. Most fan oscillation problems are caused by uneven blade levels. Check
this level by choosing a point on the ceiling above the end of one of the
blades. Measure this distance. Keeping the measurement within 3mm,
rotate the fan until the next blade is positioned for measurement. Repeat
for each blade. To set a blade end down, insert a washer (not supplied)
between the blade and the blade holder to the screw closest to the
motor. To adjust one blade, end up, insert a washer (not supplied)
between the blade and the blade holder to the two screws farthest from
the motor.
5. If the blade oscillations are still visible, exchange two adjacent blades to
redistribute the weight and possibly cause smooth operation.
The light does not ignite
1. Check the terminal connections are tight.
2. Check for blown bulbs
3. If the light is still not working contact an electrician.
Instructions for use
English
7