Cleaning And Maintenance; Troubleshooting - Mobicool DC/AC Instrucciones De Uso

_Mobicool.book Seite 10 Freitag, 6. Mai 2011 10:44 10

Cleaning and maintenance

6.3 Connecting to the cigarette lighter
NOTE
I
If you connect the cooler to the cigarette lighter, remember that the
ignition must be turned on to supply it with power.
7 Cleaning and maintenance
WARNING!
!
Always disconnect the device from the mains before you clean and
service it.
NOTICE! Risk of damage
A
Never clean the cooler under running water or in dish water.
Do not use abrasive cleaning agents or hard objects during
cleaning as these can damage the cooler.
Occasionally clean the device interior and exterior with a damp cloth.
8

Troubleshooting

Problem
Your device is not
working (plug is
inserted).
When operating from
the DC socket (ciga-
rette lighter):
The ignition is on and
the cooler is not work-
ing.
10
Possible cause
There is no voltage flowing
from the DC socket (ciga-
rette lighter) in your vehicle.
No voltage present in the
AC voltage socket.
The inner fan or the cooling
element is defective.
The fuse of the DC plug is
dirty. This results in a poor
electrical contact.
The fuse of the DC plug has
blown.
The vehicle fuse has blown. Replace the vehicle's DC socket fuse
Mobicool DC/AC
Suggested remedy
The ignition must be switched on in
most vehicles to supply current to the
cigarette lighter.
Try using another plug socket.
This can only be repaired by an
authorised repair centre.
If the plug of your cooler becomes very
warm in the DC socket fitting, either the
fitting must be cleaned or the plug has
not been assembled correctly.
Replace the fuse of the DC plug with
one of the same rating.
(usually 15 A). Please refer to the
operating manual of your vehicle.
EN