Zoom 5821F Guia Del Usuario página 2

If you'd like, you can click on the box that says Save this
password in your password list. Now click the OK box to
launch your ATA Manager. To configure your ATA, go to
Quick Setup of a Zoom ATA for Use with a SIP VoIP
Service below.
Installing the Zoom ATA Manager for non-
Windows Computers
First you need to find the IP address of the ATA, so you can use
your computer's browser to log into the Zoom ATA Manager.
To do this, first log into your router and find a list of DHCP
clients.
Do you see only one client with a MAC Address that starts
with 00 40 36?
Yes. This is your ATA. Select the corresponding IP Address,
copy it into your browser's address bar, and press the Enter key
on your keyboard. When using the ATA Manager, you should
initially use administrator for User Name and metamorph for
Password.
administrator
User Name:
metamorph
Password:
To configure your ATA, go to Quick Setup of a Zoom ATA for
Use with a SIP VoIP Service below.
No. Unplug the ATA from power. With your router's DHCP
client list on-screen, Refresh the list and then note the IP
Addresses of all remaining devices with MAC Addresses that
start with 00 40 36. Now plug the ATA power back in, and wait
about a minute. Refresh the DHCP client list again. There should
be a new device with a MAC Address starting 00 40 36 that was
not present when your ATA was unplugged. Select the
corresponding IP Address, copy it into your browser's address
bar, and press the Enter key on your keyboard. When using the
ATA Manager, you should initially use administrator for User
Name and metamorph for Password.
administrator
User Name:
metamorph
Password:
To configure your ATA, go to Quick Setup of a Zoom ATA for
Use with a SIP VoIP Service below.
2