Vaisala AP10 Guía Rápida página 6

3. A setup wizard starts when AP10 is first powered up. Use the touch interface to complete
the wizard:
a. Select a language for the touchscreen display. The selected language will be used
after the setup wizard has been completed.
b. Configure the network settings so that AP10 can join the network:
• Select DHCP if you are connecting the access point to a network that assigns
network configuration settings automatically.
• Select Static to configure network settings manually. Using the information
supplied by your IT administrator, enter the AP10 IP address, Subnet mask, and
Default gateway.
DHCP is the most common way to assign network settings. Do not use a
static address unless your IT administrator has instructed you to do so.
Note that many corporate networks require devices to be registered
before they can connect. In that case, you must provide the MAC address
of the access point to your IT administrator. The MAC address is marked
on the front of the access point (near the Ethernet connector) and on its
type label in the back.
c. Configure the Network Time Protocol (NTP) servers that the access point will use. If
you have a local NTP server in the network, replace one of the default servers with its
IP address or hostname.
d. Select a VaiNet channel (1 ... 8). Each access point in range of each other must have a
unique channel assigned to it.
e. Enter the IP address or hostname of the viewLinc Enterprise Server. Leave the TCP
port at default 12600 unless you know it has been changed.
f. Enable Installation mode to start connecting new data loggers to your system.
g. Wait for the display to change to the home screen.
4. If the setup wizard has already been completed previously, press the
the Settings screen and check all of the settings listed in
There are some optional settings that are not included in the setup wizard. For example,
you can change the brightness of the display and the LED, and prevent the changing of
settings if the user does not know the password. The default password is ap123456.
6
symbol to open
step 3.
M211821EN-F