Using The Remote Control - Hisense AP1019CW1G Instrucciones De Uso

Temperature
NOTE:
In the Cooling mode, the temperature
■
61°F and 86°F (16°C and 30°C)
In Fan Only mode, the temperature can not be set.
■
The unit LED shows the target temperature for 5 seconds
■
and then displays the room temperature.
Insert the Batteries
1. Remove the battery cover along the arrowed direction.
2. Insert new batteries making sure that the (+) and (-) of
battery are matched correctly.
3. Re-attach the cover by sliding it back into position.
NOTE:
Use 2 standard AAA(1.5volt) batteries. Do not use rechargeable
■
batteries.
Replace batteries with new ones of the same type when the
■
display becomes dim, or after 6 months.
When replacing batteries, always replace both batteries with new
■
batteries. Do not mix old and new batteries. Do not mix alkaline,
standard( carbon-zinc), or rechargeable (ni-cd, ni-mh, etc)
batteries.
If the air conditioner will not be used for an extended period of
■
time, remove the batteries from the remote.
CAUTION
Do not use the remote if the batteries have leaked.
■
The chemicals in batteries could cause burns or other health hazards.
Storage Tip
can be set between
.
Change display between °F and °C
To change the temperature display between
press both the Plus and Minus Adjust buttons at the same
time.
ION (Optional)
How to Use
To operate the room air conditioner, aim the remote
control at the signal receptor. The remote control
will operate the air conditioner at a distance of up to
23'(7m) when pointing at signal receptor of the air
conditioner.
13
°F and °C