4. Remove the flexible exhaust hose and store with the air
conditioner in a clean, dry area. See installation
Instructions . "
5. Remove the window kit and store with the air conditioner in a
clean, dry area. See " Installation Instructions . "
6. Remove the filter and clean. See Cleaning the Air Filter.
7. Clean the outside of the air conditioner. See "Cleaning the
Outside . "
8. Reinstall the filter.
Air conditioner will not operate
Plug into a grounded 3 prong outlet. See "electrical
Requirements."
Replace with a time-delay fuse or circuit breaker of the
correct capacity. See "electrical Requirements . "
Press and release RESET (listen for click; Reset
button will latch and remain in) to resume operation.
Replace the fuse, or reset the circuit breaker. See
"
Electrical Requirements .
Press ON/OFF.
Wait for power to be restored.
Air conditioner blows fuses or trips circuit breakers
"
"
Before using the air conditioner again:
1. Make sure the filter and drain cap are in place.
2. Check the power cord to make sure it is in good
condition, with no cracks or damage.
3. Place new batteries in the remote.
4. Install the air conditioner. See "Installation Instructions".
Air conditioner power supply cord trips (Reset button
pops out)
Air conditioner seems to run too much
Air conditioner runs for a short time only, but room is
not cool
Set temperature is close to room temperature.
■
Lower set temperature. See " portable Air Conditioner Use . "
Display error code
17