Bebecar SN-LA3 Instrucciones página 12

GBR
11 - After passing through the carrycot base, make sure that metal bracket (B3) lies
flat against the carrycot.
12 - Lift the carrycot liner and position the head bumper (J) into the carrycot then
reposition the liner.
Make sure that head bumper (J) is positioned to protect the child's head.
13 - To release shoulder belts press the centre of the buckle as indicated.
14 - To fasten belts together, first join both shoulder halves together, as shown.
15 - Then insert both halves into the main buckle.
16 - TO ADJUST THE SHOULDER BELT: Press the thumb lever and pull the back
section of strap to increase the length, or the front section of strap to reduce the
length of shoulder belt.
17 - To attach the adapter to the carrycot:
to the metal knob at each end of the carrycot.
When facing the back seat of car make sure that adapter metal hook (R) is on the
left side and metal adapter hook (L) is on the right side.
18 - The carrycot can be fixed to the car seat, either in the middle or to one side.
Take care to fit the carrycot firmly against the backrest of the car seat.
To attach the adapter hook to the car safety belts:
I) Pass the car safety belt through the gap in the metal adapter and swing the
metal bar between the car safety belt so that the two are attached.
II) Then pull on car safety belts to check it is secure.
III) Attach car safety belts to metal adapter on both sides (L) and (R).
ATENTION
Always make sure the belts, which fasten the carrycot and the KIT safety system, are
correctly adjusted and the internal protection is well fitted to the child's body.
In case of accident, the carrycot and the KIT safety system must be renewed.
This product has been designed and manufactured to provide a high-level of comfort
and safety for your baby.
Correct use and maintenance is vital.
The baby should not be left alone in the carrycot.
GUARANTEE
All BÉBÉCAR products have a period of guaranteed subject to the local law of the
country in which it is being sold, from the date of purchase, against mechanical
defects which will be repaired, or parts replaced free of charge within this period. This
is conditional upon the product having been used for the purpose for which it was
designed and no liability is accepted for defects arising out of fair wear and tear,
undue force, neglect or accident.
In furtherance of their policy of continuous product development BÉBÉCAR
reserve the right to make specification and design changes.
Simply anchor the metal adapter hooks