Technical Specifications - Safescan 85 Manual

Ocultar thumbs Ver también para 85:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
ENGLISH
| NEDERLANDS | DEUTSCH | FRANÇAIS | ESPAÑOL | ITALIANO | PORTUGUÊS
NOTES:
Auto switch off: The machine automatically switches to standby mode after 5 minutes (you do need to switch
off with the power switch as the machine is still using power in standby mode)
If the blue light is blinking, the batteries need to be changed
To avoid detection errors, please tidy up the notes and do not test the following notes:
A. Seriously dirty notes
B. Torn, fragmentary notes
C. Notes stuck together with sticky tape or other adhesive.
3. Maintenance
Clean all the sensors in the machine regularly, as described below: (See figure 3)
A.Remove the upper cover carefully.
B.Clean the dust on the surface of the sensors with the clean brush, or a cotton tip with alcohol.
C Reinstall the upper cover
Do not take out the sensors or try to disassemble product.
FIGURE. 3
SENSOR

4. Technical Specifications

Operating temperature
Ambient humidity
Power source
Power consumption after power-off
Dimensions
Net weight
5. Warranty
Warranty procedure
Contact Safescan for assistance: www.safescan.com
This product is in compliance with the essential requirements and other relevant
provisions of the applicable European directives. The Declaration of Conformity (DoC) is
 
available at www.safescan.com
If possible, bring the machine to a recycling centre after usage. Do not throw away the
product with the household waste.
 
03
UPPER COVER
SUBASSEMBLY
LOCK
MID COVER
0º ~ 40º Celsius
< 90%
3 x AAA batteries or 4.5V adaptor 220V
≤100 -150µA
95x61x25mm
73g

Publicidad

Tabla de contenido
loading

Tabla de contenido