LUND 26410027 Instrucciones De Instalación página 3

Installation Steps
Starting with the passenger side first mounting location slide 3002-
A up behind the urea tank and hook the tab into the bolt hole. Pull
down and align with pinch weld.
3002-A
6
Moving to the passenger side second mounting location
place a u-nut into the hole and secure bracket 3002-B
8
Align running board brackets so that the slots in the
brackets align with the holes located in Step 9. Thread
a bolt with lock and flat washers in the top bracket hole
and into the top hole in the rocker panel. Do not tighten
at this time. Repeat for remaining bracket mounting
10
Install bolt and washer
NOTE: Actual application may vary slightly from illustrations.
using a M8 bolt.
3002-B
locations.
Mounting bracket shown in place in picture below.
7
Install (2) U-nut clip at remaining hole locations.
9
Thread another bolt with washers through the lower
bracket hole, and into the U-nut. Repeat for remaining
11
Page 3 of 4
bracket mounting locations.
Install bolt and washer
Install U-nut