Zipper Maschinen ZI-STE2000IV Manual De Instrucciones página 19

Ocultar thumbs Ver también para ZI-STE2000IV:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 43
Führen Sie diese Schritte aus / Perform these steps / Lleve a cabo estos pasos /
Effectuez ces étapes / Proveďte tyto kroky / Vykonajte tieto kroky
Izvedite te korake
Schritt 1 / step 1 / Paso 1 / Étape 1 / Krok 1 / Korak 1
Stellen Sie zunächst sicher, dass genügend Treibstoff und
Motorschmierung vorhanden ist und der Schalter auf
ist.
 Make sure that enough fuel and engine lubrication is initially
securely in place and the switch is set to
 En primer lugar, asegúrese de que haya suficiente gasolina y
lubricación del motor está presente y el conmutador está ajustado
en "ON".
 Tout d'abord, assurez-vous qu'il ya suffisamment de carburant et
de lubrification du moteur est présent et le commutateur est réglé
sur "ON".
 Nejprve se ujistěte, že je dostatek paliva a mazání motoru je
přítomen a přepínač je nastaven na "ON".
 Najprv sa uistite, že je dostatok paliva a mazanie motora je
prítomný a prepínač je nastavený na "ON".
 Najprej se prepričajte, da je dovolj goriva in mazanje motorja je
prisotna in stikalo je nastavljeno na "ON".
Schritt 2 / step 2/ Paso 2/ Étape 2 / Krok 2 / Korak 2
Schließen Sie den Tankdeckel bis der Knopf "OFF" anzeigt.
Close the tank cover until the button "OFF" displays.
Cierre la tapa del depósito hasta que el botón aparezca "OFF".
Fermez le couvercle du réservoir jusqu'à ce que le bouton affiche
"OFF".
Uzavřete kryt nádrže, dokud se tlačítko "OFF" displeje.
Uzavrite kryt nádrže, až kým sa tlačidlo "OFF" displeja.
Zaprite pokrov rezervoarja, dokler gumba "OFF" zaslonov.
Schritt 3 / step 3 / Paso 3 / Étape 3 / Krok 3 / Korak 3
 Ziehen Sie den Kolben bis zum Ende hoch und drücken Sie ihn 3 - 4
mal auf und ab.
Pull the plunger to the end up and push it 3-4 times up and
 Tire del émbolo hasta el final y empujarla 3-4 veces arriba y abajo.
Tirez sur le piston à la fin et pousser 3-4 fois haut et en
Vytáhněte píst pro koncového nahoru a zatlačte ji 3-4 krát nahoru a
dolů.
Vytiahnite piest pre koncového hore a zatlačte ju 3-4 krát hore a
dole.
 Potegnite bat do konca navzgor in ga potisnite 3-4 krat gor in
Schritt 4 / step 4 / Paso 4 / Étape 4 / Krok 4 / Korak 4
 Starten Sie den Generator 1 - 2 Mal und dieser sollte nun starten.
Start the generator 1 - 2 times and this should
ZIPPER MASCHINEN GmbH
ZI-STE2000IV
www.Zipper-Maschinen.at
"ON"
gestellt
"ON".
down.
bas.
start.
TECHNIK / TECHNIC
dol.
19

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

912003923913 2

Tabla de contenido