Epson Ni-MH Manual Del Usuario página 10

4. When the batteries are fully charged, the light goes off. To
charge your batteries again, unplug the AC power cord then
plug it again.
Note:
The charger light flashes to indicate changes in battery temperature
and voltage. If the charger light continues to flash more than half
an hour, the batteries may be damaged or worn out. Replace them
with new Ni-MH rechargeable batteries.
5. After the light goes off, unplug the charger. To avoid
overcharging, don't leave the charger plugged in for long
periods of time after the light goes off.
6. Batteries that have just been charged are very hot (approx.
65°C) so handling should be kept to a minimum. Batteries
will cool down within about one hour.
7. Before storing the charger, disconnect the AC power cord
and remove the batteries.
8