GE DCVH480EK Manual Del Propietário página 21

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SIDE VENTING:
Dryer Exhaust to side of cabinet
WARNING –
PERFORMING THIS EXHAUST INSTALLATION, BE
SURE TO DISCONNECT THE DRYER FROM ITS
ELECTRICAL SUPPLY. PROTECT YOUR HANDS
AND ARMS FROM SHARP EDGES WHEN
WORKING INSIDE THE CABINET. BE SURE TO
WEAR GLOVES.
Right
Remove
screw and
save
Bottom
Remove desired
knockout (one only)
Detach and remove the bottom, right or left side
knockout as desired. Remove the screw from the
rear of the casing and save. Pull the duct out of
the dryer.
Cut the duct as shown and keep portion A.
Installation Instructions
BEFORE
Left
Tab
Fixing hole
A
4.9" (125 mm)
ADDING A NEW DUCT
Fixing hole
Left side
exhaust
Reconnect the cut portion (A) of the duct to the
blower housing. Make sure that the screw holes
in the duct and ramp base are aligned. Use the
screw saved previously to secure the duct in place
through the ramp on the appliance base.
ADDING ELBOW AND DUCT FOR EXHAUST
TO LEFT OR RIGHT SIDE OF CABINET
• Tape the connection between the duct and elbow.
• Insert the duct with elbow through the rear
opening and connect to the internal duct.
CAUTION:
damage the electrical wires inside the dryer when
inserting the duct. A slight interference may
occur between the exhaust and the wire
components.
• Apply duct tape as
shown on the joint
between the dryer
internal duct and
the elbow, and also
the joint between the
elbow and the side duct.
CAUTION:
secured with tape; otherwise, they may separate
and cause a safety hazard.
21
Portion "A"
Be sure not to pull or
Duct tape
Internal duct joints must be

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dcvh485ekPcvh480ekPcvh485ekDcvh480ekww

Tabla de contenido