Hoover RUCH TCR418 Manual De Instrucciones página 4

USING YOUR CLEANER
1. Extract power cord and plug it into the power supply. Do not pull the cord beyond the
red marker. [5]
2. Adjust the telescopic tube to the desired height by moving the telescopic release
button up and raise or lower the handle to the most comfortable cleaning position. [6]
3. Select carpet care control height by pressing the pedal in the nozzle. [7]
Hard Floor – Brushes are lowered to protect the floor.
Carpet – Brushes are raised for the deepest clean.
Switch the cleaner on by pressing the On/Off Button on the cleaner main body. [8]
4.
Adjust the power control regulator to the desired level.* [9]
5.
Adjust the suction regulator on the handle to the desired level. [10]
6.
7. Switch off at the end of use by pressing the On/Off Button. Unplug and press the cord
rewind button to wind the power cord back into the cleaner. [11]
8. To store your cleaner adjust telescopic tube to the lowest height setting and park the
nozzle in the park position on the cleaner main body. [12]
ACCESSORIES
All accessories can be fitted to the end of the handle or the end of the telescopic tube.
3 in 1 tool – Combines several functions in one. The 3 in 1 tool can be stored neatly un-
derneath the hose handle.
Crevice Tool – For corners and hard to reach areas. [13]
Furniture Nozzle – For soft furniture and fabrics [14]
Dusting Brush – For bookshelves, frames, keyboards and other delicate areas. To ex-
tend thebrushes push the button on the body of the tool. [15]
Parquet Nozzle* – For parquet floors and other delicate floors.
Grand Turbo Nozzle* – Use the turbo nozzle for deep cleaning on carpets.
Pet Hair Remover Mini Turbo Nozzle* - Use the mini turbo nozzle on stairs or for deep-
cleaningon textile surfaces and other hard to clean areas. Particularly suitable for pet hairs
removal.
Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep-
cleaning on textile surfaces and other hard to clean areas. Particularly suitable for allergen
removal.
IMPORTANT : Do not use the turbo and mini turbo nozzles on rugs with long fringes,
animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary while
the brush is rotating.
(*Certain models only)
rosie 48000686 -01- rush ML IM.indd 2
CLEANER MAINTENANCE
Emptying the Dust Container
When the dust reaches the max level indicator in the container empty the dust container.
IMPORTANT : To maintain optimum performance do not allow the dust to sit higher than
the max level.
1. Release the container by sliding the bin release button towards the rear of the cleaner.
[16] Lift the dust container from the cleaner main body.
2. Hold the dust container over a bin with one hand and press the bin container door
open trigger. [17]
3. Close the dust container door and refit to the cleaner main body.
Cleaning the washable filters
The cleaner is fitted with a blue filter pack. To maintain optimum cleaning performance
regularly remove the the filters and tap against the side of the bin to release dust. The filters
should be washed every 5 cassette empties or when the filter has excessive dust level.
IMPORTANT: All bagless cleaners require regular filter cleaning. Failure to clean
your filters may result in air blockage, overheating and product failure. This may
invalidate your guarantee.
IMPORTANT:
Regularly check and maintain the filters.
IMPORTANT:
Always ensure the filter pack is fully dry before use.
To access the filter:
1. Release the container by sliding the bin release button towards the rear of the cleaner.
[16] Lift the dust container from the cleaner main body.
2. Hold the bin with one hand and with the other hand rotate the bin handle anti clockwise
to release from the bin container. [18]
Remove the blue filter unit located in the bin handle. [19]
3.
Separate the foam filter from the filter pack. [20]
4.
5. Gently tap and wash the grey foam filter using warm water. Do not use hot water or
detergents. Remove excess water from the filter and leave to dry fully before re-using.
[21]
6. Gently tap and wash the blue filter unit. Do not use hot water or detergents. Remove
excess water from the filter and leave to dry fully before re-using. [21]
7. Reassemble to filter pack once fully dry and refit to the cleaner.
IMPORTANT:
Do not use the product without the filter pack fitted.
To access the exhaust filter:
1. Unclip the exhaust filter from the rear of the cleaner. [22]
2. Gently tap and wash the grey foam filter using warm water. Do not use hot water or
detergents. Remove excess water from the filter and leave to dry fully before re-using.
[22]
2
GB
12/01/2011 00:17:19