Verifying Ecosystemr Lights Connected To Eco Link 1 And Link 2 - Lutron Electronics Energi Savr Node Manual De Instrucciones

Ocultar thumbs Ver también para Energi Savr Node:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 13
Energi Savr Node

Verifying EcoSystemR lights connected to ECO link 1 and link 2

WARNING! Danger of Shock. May result in serious injury or death. DO NOT WIRE WHEN LIVE! Switch off power via circuit
breaker before wiring or servicing the Energi Savr NodeT with EcoSystemR unit.
Buttons and LEDs on the front of the unit are used for troubleshooting. If wiring is exposed when accessing buttons and
LEDs, the unit must be accessed by a certified electrician, following local codes.
1. Enter Test mode: - Press and hold Test Button on the Energi Savr NodeT with EcoSystemR unit until the Test LED starts flashing.
ECO 1 button:
Each button press cycles the lights between:
• Link 1 going to low-end
• Link 1 going to high-end
• Link 1 flash
• Link 1 going to off
ECO 2 button:
Each button press cycles the lights between:
• Link 2 going to low-end
• Link 2 going to high-end
• Link 2 flash
• Link 2 going to off
2. Exit Test mode: press and hold Test button until Test LED stops flashing.
Lutron
10
|
®
with EcoSystemR
TM
International Energi Savr Node
|
Installation Guide
with EcoSystemR Installation Guide
TM

Publicidad

Tabla de contenido
loading

Productos relacionados para Lutron Electronics Energi Savr Node

Este manual también es adecuado para:

Qsne-2eco-d

Tabla de contenido