Electrical Supply - Delabie TEMPOMATIC Manual De Instrucciones

DRY WALLS
• To attach the box using the 4 legs, strengthen
the dry wall with 2 brackets.
• Seal the inside and lower edge of the box with
mastic to prevent any water leaking into the
wall. Position the silicone seal behind the
stainless steel wall plate to ensure a waterproof
seal between the wall plate and the wall. Leave
a drainage point to allow any residual water to
drain away.
FIXING THE COVER
• Once the wall has been lined, attach the strips
onto the stainless steel case with 4 screws,
ensuring that they are level.
• Install the hydraulic unit.
• Feed the detector and solenoid valve cables
through the sheath.
• Connect the flexible to the spout and the
solenoid valve.
• Snap the cover onto the upper strip. After
testing, using a 2.5mm Allen key, tighten the 2
screws under the cover to tighten in place.
• Connect the solenoid valve and complete the
installation as shown in the CONNECTION
section.
THE INSTALLER MUST ENSURE THAT:
• THE RECESSING AREA IS WATERPROOF TO
PREVENT ANY INGRESS OF WATER;
• ANY WATER ACCIDENTALLY ENTERING THE
RECESSING AREA (E.G. (CONDENSATION, RUN
OFF, LEAKS, ETC.), IS NOT STAGNANT AND
HAS A DRAINAGE POINT;
• THE INTEGRITY OF THE SEALS BETWEEN THE
STAINLESS STEEL WALL PLATE AND THE WALL
OR THE WALL PLATE AND THE MIXER/TAP AT
LEAST ONCE A YEAR, AND MAKE GOOD IF
NECESSARY.
If this advice is not followed, water may
leak into the wall. DELABIE cannot be held
responsible for any ingress.
FOR FURTHER INFORMATION PLEASE CALL
TECHNICAL SUPPORT (SEE BELOW FOR
CONTACT DETAILS).

ELECTRICAL SUPPLY

• Electrical supply: 220-240V / 50 Hz class II
without earth connection. Install a 30 mA