Operating Position - Black and Decker NPP2018 Manual De Instrucciones

625116-00 NPP2018 Pole 11/12/04
Switch
Always be sure of your footing and grip the
Pole Saw firmly with both hands with the
thumb and fingers encircling the handle.
To turn the tool ON pull the lock button (1)
back with your thumb and then squeeze
the trigger (2) with your fingers as shown
in figure 21. (Once the tool is running you
can release the lock button.) To turn the
tool OFF, release the trigger.
Auto-Stop Chain Braking System
Your chain saw is fitted with an auto-stop chain braking system which
will stop the chain quickly each time you release the rear trigger, or if
kickback should occur. This system should be tested before every
use.
9:11 AM Page 11
21
• Keep other persons at least 50 feet (15m) from the
• Electrocution Hazard. To prevent shock, do not
• Do not extend Pole Saw switch handle above
11

Operating Position

Always Wear:
Head Protection
Eye Protection
Work Gloves
Long Pants
Steel Toed Shoes
cause you to loose your balance and cause severe injury.
work area. Distractions can cause you to lose control.
operate within 50 feet (15m) of overhead electrical
lines. Always check surrounding area for hidden
electrical lines.
shoulder height.
Pole Saw Trimming /
Pruning
Warnings:
• Never stand directly
under the limb you
are cutting. Always
position yourself out of
the path of falling
debris.
• Always wear head,
eye, foot and body
protection. Wearing
body protection helps
reduce the risk of
injury when operating
this unit.
• Never
stand on a
ladder or
other
unstable
support
while using the Pole
Saw. Always avoid
any position which can