Black and Decker NPP2018 Manual De Instrucciones página 13

625116-00 NPP2018 Pole 11/12/04
Accessories
Replacement chain and bar are available from your nearest Black &
Decker service center.
Replacement chain # 623382-00
Replacement bar # 623381-00
The use of accessories not recommended in this manual may be
hazardous.
9:11 AM Page 13
13
Troubleshooting Section
If your Pole Saw does not operate correctly check the following:
Problem Possible Cause
• Tool will not • Battery not
start. installed properly.
• Battery not
charged.
• Lock-out button not
actuated.
• Pole connections
not properly
tightened.
• Battery not
• Unit will not
inserted into
charge.
charger.
• Bar / chain
• Chain too tight.
overheated.
• Lubrication
needed.
• Chain is • Chain tension set
loose. incorrectly.
• Poor cut • Chain tension set
quality. incorrectly.
• Chain needs
replacement.
Possible Solution
• Check battery installation.
• Check battery charging
requirements.
• Pull back on lock
button/actuate trigger.
• Refer to instruction manual
for pole connections.
• Insert battery into charger
until red LED appears.
Charge up to 8 hours if
battery totally drained.
• Refer to section on
adjusting chain tension.
• Refer to sections for chain
oiling application.
• Refer to section for chain
tensioning.
• Refer to section on
adjusting chain tension.
Note: Excessive tension
leads to excessive wear
and reduction in life of bar
& chain.
Lubricate after every 10
minutes of use.
Refer to section for
installation of chain.