Technical Data - secudo D 150 Manual De Instrucciones

Note that metal surfaces and walls containing metal can
severely dampen or reflect the radio signals (Fig. 4).
Maintain a minimum distance of one metre between the
radio modules and the N 100 (Fig. 5) during installation.
Maintain a minimum distance of one metre from large
appliances (Fig. 6).
Follow the instructions for the smoke detector when
determining the installation location. Install the radio modules
on the ceiling. The radio range is greatest in the direction
of the marking on the housing of the radio module (Fig. 7).
Plug the three-pin terminal of the radio module (Fig. 1.3) onto
the underside of the smoke detector (Fig. 2). Put the smoke
detector onto the installed radio module and carefully turn
the smoke detector in a clockwise direction until it locks into
place. During this process, the marking on the housing of the
radio module and the marking on the housing of the smoke
detector must align with each another (Fig. 7). If a battery is
not inserted into the smoke detector, it is not possible to lock
the smoke detector in place on the radio module.
Note:
Make sure that the connection wires are not routed over the
circuit board of the radio module — instead, they must be
routed directly from the edge of the housing to the three-pin
plug on the radio module.
Once all radio modules/smoke detectors are installed,
perform a function test by pressing the test button on the
smoke detector until the smoke detector emits three alarm
sounds. When performing the function test, follow the
instructions for the smoke detector. The radio modules/
smoke detectors of the same radio group signal the alarm
acoustically and automatically return to normal mode after
a short period of time. If a detector forwards the OUT signal,
it acknowledges that it has done so by emitting three short
sounds. See the section entitled "Operation/testing".
Recycling guidelines
This device must not be disposed of as unsorted
household waste. Used devices must be disposed
of correctly. Contact your local town council for
more information.
Warranty
You can find our general terms and conditions by visiting
our website at www.secudo.com.

Technical data

Type designation: D 150
Battery operation: 9-V ULTRALIFE U9VL-J-P
Frequency: 0–868 MHz
Relative humidity: 0–90% non-condensing
Working temperature range: 0–40°C
Colour: white
Dimensions: Ø 106 mm, height 12 mm
Item number: 90100176
Technical and design features may be
subject to change.
NOTE: Secudo GmbH hereby declares that the D 150
complies with the basic requirements and other relevant
provisions of Directive 1999/5/EC. The full text of the
declaration of conformity can be found at: www.secudo.
com.
71