After Using Your Pressure Washer; Storing The Washer; Storage Of Accessories - Berner BHPC 150-1 Manual De Instrucciones

BHPC 150-1

6 After using your pressure washer

DE
EN

6.1 Storing the washer

FR
IT
ES
6.2 Winding up of electric
cable and high pressure
hose

6.3 Storage of accessories

28
128303560_BHPC_150-1.indb 28 128303560_BHPC_150-1.indb 28
The machine should be sto-
red in a frost-free room!

Pump, hose and accessories
should always be emptied of
water prior to storing as follows:
1. Stop the machine (turn the
start/stop switch (1) to posi-
tion "O" and detach water
hose and accessory.
2. Restart the machine and
activate the trigger. Let the
machine run until no more
water runs through the spray
handle.
3. Stop the machine and un-
plug. Wind the electric cable
round the hooks placed on
the side of the machine.
A
4. Separate spray handle and
high pressure hose.
5. Coil the high pressure hose
up on the hose reel.
6. Place spray handle, nozzles
and other ac ces so ries in the
holders of the machine.
Should the machine by mistake
be frozen, it will be necessary
to check it for damage.
NEVER START-UP A FROZEN
MACHINE.
Frost damages are not
covered by the guarantee!
To avoid accidents, the electric
cable and the high pressure
hose should always be wound
up carefully.
1. Wind up the electric cable on
the appropriate hooks. Built-
in clip for good holding.
The lower hook can be
turned to release the electric
cable.
2. Coil the high pressure hose
up on the hose reel.
The standard accessories
(spray handle, spray lance
(A) and nozzle cleaning tool)
can be stored on the pressure
washer.
Original Instructions
25-02-2011 10:34:39 25-02-2011 10:34:39