Viatom Wellue B02 Manual Del Usuario página 7

2. To prevent the damage of monitor from leaked battery fluid, please
take out of battery if the monitor unused in a long time (generally more
than 3 months). If battery fluid should get in your eyes, immediately
rinse with plenty of clean water. Contact a physician immediately.
3. Attached battery is only for testing the function of the monitor, Long-
life alkaline batteries are recommended.
4. Dispose of the device, components and optional accessories
according to applicable local regulations. Unlawful disposal may cause
environmental pollution.
5. Battery is dangerous stuff, do not mix it with other rubbish.
System Settings
After you load the battery or connect power for the monitor, press the
Setting button and hold it for more than 3 seconds, and then you can
start to set:
Setting the Year:
When the display is flashing, press the memory button, the year will
increase by 1 year each, hold the memory button and it will increase
continuously 1 by 1, Press the SET button to enter next step.
Setting Month/Date:
Initial Month/Date is 1/01, when the display is flashing, press the
memory button, the month will increase by 1, press Setting button to
confirm, and do in the same way to Setting the date. Press Setting
.
button to confirm
Setting Time:
There is 1 mode for time 24-hours, when display with sy.press MEM
button to set the time mode, Press the SET button to enter next step.
Setting Unit:
This monitor has 1 mode for blood pressure measurement.
MmHg. Setting button to confirm.
Record delete:
When you checking the measurement data, long press memory
to delete exist user measurement data. Choose the Users button
between A and B to delete date record for each user.
Note:
You can't delete single measurement record. If you delete the
record, you will delete all. Please keep the record in another way,
in case you need it some days later. Take the battery out won't
lead to a record missing.
Cuff tube connection
Insert the cuff tube into the opening on the left side of the monitor č As
shown in picture-06)