Craftsman CMXGZBF71243311 Manual De Instrucciones página 10

ENglISh
Step 19: (fig. 19)
1. Place a long spacer tube (20) onto the shaft. See figure
19.
Fig. 19
20
Step 20: (fig. 20)
1. Place two spike disks (7), separated by a long spacer
tube (20), onto the shaft. Fit the long spacer tube onto
the ends of the flanged bearings in the disks. See figure
20.
Fig. 20
20
8
7
Step 21: (fig. 21)
1. Place a long spacer tube (20) onto the shaft.
2. Place two spike disks (7), separated by a long spacer
tube (20), onto the shaft. Fit the long spacer tube onto
the ends of the flanged bearings in the disks. See figure
21.
Fig. 21
20
Step 22: (fig. 22)
1. Place a short spacer tube (41) and then a large washer
(38) onto the shaft. Fit the short spacer tube and washer
onto the end of the flanged bearing in the end plate.
Push the shaft on through the flanged bearing in the
end plate. See figure 22.
Fig. 22
38
7
41