Regalo Home Accents Widespan 1176 B Manual De Instrucciones página 4

Removing Extension Gate
STEP 1
If the standard gate is too long for your opening
you must remove either the right or left
extension gate. Loosen the hinge knob in the
clockwise direction. Slide the hinge knob down
and pull out the tube hinge. Do the same with
the tube hinge on the end with the wall mounts.
Gate Operation
STEP 1
UNLOCKED
To open the gate, start with rotating the base lock in the
upward direction. Do this on both sides of the door.
NOTE:
You can rotate the base lock in either direction.
STEP 2
Remove the hinge cover cap. Hinge cover cap
(H) is on the bottom of the hinge with the wall
mounts. Remove the toothed hinge cap from
the top.
STEP 2
LOCKED
Press the release button down on the handle. Slide the handle back towards the
hinge.
NOTE:
When closing the gate you must do the same operation.
Handle is spring loaded and will return to its "locked" position on its own.
STEP 3
Place the tube hinge, wall mounts, hinge knob,
and cap hinge cover into the lower door frame.
Place the toothed hinge cover on the top of the
gate. Slide the hinge knob up into the toothed
hinge cover and twist counter-clockwise to
tighten. Once the hinge knob is tight lower the
cap hinge cover all the way down.