Replacement Parts - Regalo 1185 Manual De Instrucciones

Positioning and Attaching Wall Cups
STEP 1
After you have mounted your gate, and you are
satisfied with its positioning, draw a circle on
the surface of your doorway or opening around
the perimeter of the (4) rubber feet. Next,
completely remove the gate from the opening by
loosening each of the (4) threaded spindle rods
to depressurize the gate.
Adding a Gate Extension
STEP 1

Replacement Parts

A
Hardware Kit #14085 Includes:
Threaded Spindle Rods w/ Adjustment
Wheel (4), 1" Wall Mount Screws (4),
Wall Cups (4), Binding Post (1),
Hex Key (1)
STEP 2
With the gate fully removed, you can now use the
circles you marked during Step 1 as guides for
screwing in your (4) wall cups (D). Center each of
the wall cups within the guide circles and use the
provided self-tapping screws (E) to fasten them in
place via the hole through the center of each wall
cup.
Need more width? Additional extensions sold separately www.regalo-baby.com
Hardware Kit
Reinstall your gate in the doorway or
opening according to the instructions, using
the newly installed wall cups as anchoring
points for the (4) threaded spindle rods.
Choose the side of the gate to be extended and remove the top and bottom
threaded spindle rods.
Assemble the gate and extension as illustrated. Reposition the gate and fit
in accordance with the gate fitting.
NOTE:
It is preferable to install any extensions on the hinge side of
the gate. If you have an application that requires additional extensions,
please contact the manufacturer.
90 DAYS LIMITED WARRANTY
If, during the first 90 days after consumer purchase of the
item, under reasonable and non-commercial use and
conditions of maintenance, it fails while owned by the original
purchaser because of the quality of materials or workmanship
of finish and assembly, Regalo International, LLC, will replace
or repair it at Regalo's option. PROOF OF PURCHASE
REQUIRED.
STEP 3