Danby DIM3225BLSST-RM Guía De Utilización Y Cuidado Para El Propietario página 10

Occasionally, a problem is minor and a service call may not be necessary - use this trouble shooting guide for a possible
solution. If the unit continues to operate improperly, call an authorized service depot or Danby's toll free number
1-800-263-2629.
1 "Water tank is full" - troubleshoot using instructions before contacting an authorized service centre.
a) Disconnect from power source. Unscrew the drain cap located on the back of the unit and let out the water (refer to
installation guide)
b) After draining out all the water from the outside water tank, reconnect unit to power and it will continue to run normally.
c) If "drain pump mode" (see separate installation instructions) is being used, please confi rm the "drain pump switch" is in the "ON"
position.
2
"Ice maker low on water" - troubleshoot using these instructions before contacting an authorized service centre.
a) Check if outside water supply is functioning normally. Follow "checking the water supply" instructions (above) and wait 30 minutes
for the unit to correct itself.
b) If this doesn't work, press the power button to restart the unit.
3
"Sensor breakdown" - contact our authorized service center for maintenance.
4
"System malfunction" - System will shut down call an authorized service center.
Visit http://www.profi leofgoodtaste.com/ to view a short instillation video.
TROUBLESHOOTING
7