Operating Instructions; Indicator Lights - Danby DIM3225BLSST-RM Guía De Utilización Y Cuidado Para El Propietario

CONTROLS OF THE ICE MAKER
The ice maker should be placed where the ambient temperature is between 10-32°C (50-
90° F.) If the ambient temperature is above or below this range, the performance of the unit
may be affected.
Control

INDICATOR LIGHTS

Single Indicator light
Single Indicator light
Single Indicator light
Single Indicator light

OPERATING INSTRUCTIONS

Type Action
Button Press
Button Press
Button Press
Button Press
FLASHING
FLASHING
FLASHING
All on at the
Simultaneous
Indicator lights same time
Simultaneous 2 sizes fl ashing at the
Indicator lights same time for 15
seconds
Simultaneous All icons fl ashing at
Indicator lights
the same time
Function Explanation
To turn the ice maker
on/off (press and
hold this button for
approximately 3 seconds)
Small ice
Medium ice
Large ice
ON
Small ice is selected.
Water tank is full
1
and beeping. (see
troubleshooting section
page 7)
ON
Medium ice is selected.
Large ice is selected.
ON
2
Ice bucket is full of ice
ON
Compressor on
OFF Compressor off
Stand-by mode
Ice maker low on
water (see troubleshoot-
ing section page 7)
3
Sensor breakdown
(see troubleshoot-
ing section page 7)
System malfunction
4
(see troubleshooting
section page 7)
2
Check the water supply
1. Turn off water supply.
2. Disconnect water supply line from
the ice maker.
3. Position water supply line in a
bucket.
4. Turn on water and make sure
water pours into the bucket.
5. Turn water supply off again, then
reconnect the water supply line to
the ice maker.
* If unsure, please contact your local
plumber.