1
2
5
6
8
OK
11
12
12 V
13
15
8
8
3
12 V
9
NO
OK
NO
14
16
4
7
1 – Before using Handpresso Auto, make sure that the
vehicle is stationary, the parking brake engaged and the
engine turned on.
2 – Uncoil the power cord before installing Handpresso
AUTO vertically in the cup holder.
3 – Plug the power cord to a 12V cigarette lighter plug.
4 – Unscrew the portafilter.
5 – If the ground coffee ring is placed, remove it.
6 – Fill the cup with water up to the black line, then pour
the water in the machine.If you do not have the cup,
beware not to pour too much water ! Therefore, watch
10
the water level indicators. They get darker clockwise, the
one after the other, as you add water. Pour slowly. Stop
adding water as soon as the last indicator turns black.
7 – Put an espresso pod in the pod holder.
8 – Close the pod portafilter by rotating it 60 degrees
clockwise... up to the locking indicator. Beware: the
brewing will not be possible if the pod portafilter is not
2'
properly locked!
9 – Press the ON button to start the heating cycle of the
machine.
bip x3
10 – Wait until you hear 3 bleeps (approx. 2 minutes).
Beware: When the motor noise stops, it does not mean
that the machine is ready! Wait until you really hear the
machine bleeps three times. At the end of the cycle, when
the machine is ready, the thermometer will show the
correct water temperature and the ON button will remain
lit for 1 minute.
11 – Unplug the machine.
12 – Flip the machine around, place it over a cup and
push the
appears) to pour the coffee.
13 – When the cup is filled to your liking, press the STOP
button - until the safety ring disappears – in order to stop
the coffee.
14 – Turn over the machine and place it back vertically in
its housing.
15 – Re-open the pod portafilter to remove and dispose of
the used pod.
16 – Pour out any excess water from the water reservoir.
17 – Enjoy your espresso.
To prepare the second espresso, go back to step 4.
17
instructions
for use with espresso pods
espresso button till the end (a safety ring
9
9