Replacing The Rechargeable Battery; Charging The Rechargeable Battery; Maintenance And Care; Troubleshooting - MELINERA 103382-14-01 Instrucciones De Montaje, De Uso Y De Seguridad

The light automatically switches on in twilight
conditions and off again when normal outdoor
lighting conditions return.
Replacing the
rechargeable battery
The battery should be replaced every 12 months to
ensure optimum performance.
1. Separate the solar cell housing
shade by moving it anti-clockwise (see Fig. A).
6
Switch off the lamp with the ON / OFF switch
2. For 103382-14-01 / 02 / 03: Open the
battery compartment lid of the solar cell
housing.
For 103382-14-04: Loosen the fastening
screws by using a small cross head screw-
2
driver and then lever out the battery compart-
ment lid of the solar cell housing
3
the help of a slot screwdriver (see Fig. B).
3. Exchange the old rechargeable battery
new one, ensure that you do not damage the
wiring. Take care to the correct polarity, when
inserting the new rechargeable battery. The po-
larity is indicated in the battery compartment.
The new rechargeable battery has to have the
same technical data like the old one.
4. For 103382-14-04: Now again fasten the
battery compartment lid
ing screws by using a small cross head
2
screwdriver. Slide the ON / OFF switch
position ON.
5. Connect the solar cell housing
lamp shade and then connect every part of
6
the solar lamp to each other (see Fig. D).
Charging the rechargeable
battery
Note that the solar garden light must be switched
on when the battery is charging.
The charging time of the battery when the solar cell
is used depends on the intensity of the sunlight and
the angle of incidence of the light on the solar cell.
103382_mel_LED-Solarleuchte_content_ES_PT.indd 15
Place the solar cell as perpendicular as possible to
the angle of incidence of the light. In this way you
will receive the highest light levels.
The light-emitting diodes cannot be replaced.
The solar lamp is maintenance-free, except for any
necessary change of battery.
from the lamp
5
.
1
Note: This appliance has delicate electronic com-
with ponents. This means that if it is placed near an object
5
that transmits radio signals, it could cause interfer-
to a ence. If you notice that the device is malfunctioning,
4
remove any sources of interference from the area
of the device.
Note: Electrostatic discharges may cause device
to malfunction. In the event of such malfunctions,
remove the batteries briefly and reinsert them.
Error
, fasten the fasten-
3
The light will
not switch on
to the
1
even though
the sun shone
again to the
5
on the lamp
all day.
The light does
not come on
or comes on
only briefly.

Maintenance and care

Clean the solar lamp regularly with a dry, lint-
free cloth. Use a slightly dampened cloth to
remove more stubborn dirt.

Troubleshooting

Cause
Artificial
sources of
light, e.g.
street lighting,
are interfering
with the lamp.
The recharge-
able battery
is broken or
there was
not enough
daylight.
Solution
Mount the lamp
in a place where
it cannot be dis-
turbed by other
sources of light.
Replace the re-
chargeable bat-
tery or mount
the lamp in a
place where it
can receive
more sunlight.
GB/MT 15
21.10.14 14:39