Setting Up The Product; Replacing The Rechargeable Battery; Charging The Rechargeable Battery; Maintenance And Cleaning - MELINERA 10397A Manual De Instrucciones De Montaje Y Manejo

10397C:
Connect the ground stake
(Fig. C).
4
Then push the ground stake
in the desired location.
Affix the lamp glass holder
and insert the lamp glass
4
and solar panel
6
holder (Fig. C).
10

Setting up the product

Make sure it is firmly positioned. Do not use
force when assembling or setting up the pro-
duct, e.g. hammer blows. This will damage the
product. In order to get the best possible results,
place the product in a place where the solar
cell is exposed to direct sunlight for as long as
possible.
Push the assembled product far enough into
the ground (grass, flower bed) to be stable.
Please note the assembly steps in the chapter
„Assembling the product".
Make sure the solar cell is not impacted by
other light sources, e.g. yard or street lighting,
or the light will not switch on at dusk.
The light will automatically switch on in low
light and switch off in normal daylight.
Replacing the
rechargeable battery
10397A:
Remove the solar cell housing
lamp glass .
2
Slide the on / off switch
Open the battery cover
geable battery
7
rechargeable battery of the same type AAA
(Fig. D).
Replace the battery cover
Slide the on / off switch
(Fig. E).
Place the solar cell housing
glass again.
2
to the extensions
3
into the ground
3
to the extension
10
with the LED
2
into the lamp glass
5
from the
1
to the „OFF" position.
9
, remove the rechar-
8
and replace it with a new
.
8
to the „ON" position
9
on the lamp
1
10397B / C:
Remove the solar cell housing
lamp glass holder
10
Slide the on / off switch
Unscrew the two screws (three in model
10397C) from the underside of the solar cell
housing using a screwdriver (Fig. D).
1
Fold up the solar cell housing
Remove the rechargeable battery
place it with a new rechargeable battery of the
same type AAA (10397B) or AA (10397C)
(Fig. F).
Place the solar cell housing
compartment again.
Retighten the two screws (three in model
10397C) using a screwdriver.
Slide the on / off switch
(Fig. G).
Replace the solar cell housing
glass holder .
10
Charging the
rechargeable battery
Please note that the product must be switched on
when charging the rechargeable battery. The char-
ging time via the solar cell varies by the intensity of
the sunlight and the incidence angle of light onto
the solar cell. Place the solar cell as perpendicular
as possible to incidence angle of light. This will
ensure the brightest light.

Maintenance and cleaning

The LED cannot be replaced. The product is mainte-
nance-free except for replacing the rechargeable
battery as necessary.
Do not use solvents, petrol, etc. These will
damage the product.
Regularly clean the product with a dry, lint-free
cloth. Use a slightly moist cloth if very dirty.
from the
1
.
to the „OFF" position.
9
(Fig. E and F).
1
and re-
7
on the battery
1
to the „ON" position
9
in the lamp
1
GB/IE 17