If this Craftsman product fails due to a defect in material or workmanship within two years from the date of purchase, return it to any Sears
store, Parts & Repair Service Center, or other Craftsman outlet in the United States for free repair (or replacement if repair proves impossible).
This warranty applies for only 90 days from the purchase date if this product is ever used for commercial or rental purposes.
This warranty covers ONLY defects in material and workmanship. Sears will NOT pay for:
•
Expendable items that can wear out from normal use within the warranty period, such as cutting line, filters or spark plugs.
•
Repairs necessary because of accident or failure to operate or maintain the product according to all supplied instructions.
•
Preventive maintenance, or repairs necessary due to improper fuel mixture, contaminated or stale fuel.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
On/Off Stop Control
Fuel Cap
Muffler
Spark Plug
ADJUSTING THE D-HANDLE
1.
Using a flathead or T-25 screwdriver,
loosen the 4 screws on the D-handle
enough to loosen it (Fig. 1).
2. Rotate the D-Handle to the upright
position on the front side of the
shaft housing (Fig. 1).
3. Hold the unit in the operating position
(Fig. 8). If necessary, reposition the D-
handle to the location that provides
the best grip.
4. Tighten the 4 screws until the D-
handle is secure.
CRAFTSMAN FULL WARRANTY
Starter
Rope Grip
Shaft Grip
Shoulder Strap
Loop
Air Filter/
Muffler Cover
Primer Bulb
ASSEMBLY INSTRUCTIONS
Fig. 1
WARRANTY STATEMENT
KNOW YOUR UNIT
APPLICATIONS
As a trimmer:
•
Cutting grass and light weeds.
•
Edging
•
Decorative trimming around trees, fences, etc.
Other optional accessories may be used with this unit.
Throttle Control
D-Handle
Convertible™
Coupler
Trimmer Attachment
INSTALLING THE TRIMMER ATTACHMENT
Prior to use, make sure trimmer attachment is installed correctly.
Please refer to Operating the Convertible™ Coupler System for
proper installation.
NOTE: Remove red cap or hanger from lower shaft housing prior to
assembling to Convertible™ coupler
4
Shaft Housing
Line Cutting
Blade
Cutting Shield
Hassle Free
®
Plus Cutting Head