Incidences; Appendix; System Reset; Zone Reset - Airzone RADIANT365 Manual De Instrucciones

DHW function. (Only available in installations with AZX6GAW XXX gateways) It allows to turn on/off the Domestic Heat Water
(DHW) function in the systems connected to the CCP. Activated by default.
Cooling mixing valve (only available in installations with AZX6GAW XXX gateways). Select "Auto" if you have mixing valves
for cooling in your installation. It is set to Manual by default.
ES

INCIDENCES

EN
If an error message is shown, you can check both the Installation Manual and the Self-diagnosis section. Please visit Myzone
FR
web: myzone.airzone.es/productos/
IT

APPENDIX

PT

SYSTEM RESET

DE
If you want to return to factory values, press and hold SW1 until LED D11 stops blinking. Wait for the
LEDS to go back to their normal state before starting with the initial configuration process.

ZONE RESET

Blueface and Think thermostats reset

If needed, to reset a zone follow the steps shown in the section Advanced Configuration, Zone Parameters for Blueface and Think
thermostats and the section Lite thermostat reset if using Lite thermostats.

Lite thermostat reset

If you want to return your Lite thermostat to factory values, pull down all the microswitchs and reinsert the thermostat in its
base. The LED will flash green twice when the reset process is completed.

CHANGING BATTERIES

To replace the battery, separate the thermostat from its support and
replace the battery (CR2450).
Important: We recommend using of top-brand batteries. Using low-quality
batteries may reduce the duration of use.
Remember to deposit the old battery into an appropriate recycling point.
Note: Do not forget to remove the security system before taking away the
thermostat from the wall.
30