Power Switch - PROEL SW118A Manual De Uso

full-range sat speakers, you can get a better low-frequency response in the room if you reverse the polarity of the
subwoofer's signal. Listen in different positions of the venue in order to try which is the best sounding setting.
NOTE: ALL SUBWOOFER SPEAKERS MUST BE HAVE THE SAME POLARITY, if you note a lack in lowest frequency range
using more than one subwoofer, probably you have a subwoofer inverted respect the other. Be always sure all these
switches are in same position.
12. ON indicator
GREEN LED: when lighted indicates amplifier has been turned on and AC power is available.

13. POWER switch

Speaker is "ON" when the switch is in the "I" position, use this switch to set the speaker power to ON or OFF .
NOTE: When you shut down your equipment, turn off the speaker first.When powering up, turn on the speaker last.
14. LINE VOLTAGE selector
This switch sets the AC voltage line of your country (usually it is set by factory and isn't necessary to change it). The 115V
setting is for mains line in the range of 105-120V~ and 230V setting is for mains line in the range of 210-240V~.
WARNING: an incorrect setting of AC LINE VOLTAGE could damage seriously the internal electronics!
15. FUSE holder
Here is placed the mains protection fuse.
REPLACE THE PROTECTION FUSE ONLY WITH SAME TYPE AS SHOWN ON THE PRODUCT.
IF AFTER THE SUBSTITUTION, THE FUSE INTERRUPTS AGAIN THE APPARATUS WORKING, DO NOT TRY AGAIN THEN
CONTACT THE PROEL SERVICE CENTER.
16. AC~ socket
Here's where you plug in your speaker's mains supply cord. You should always use the mains cord supplied with the
speaker. Be sure your speaker is turned off before you plug the mains supply cord into an electrical outlet.
17