Product Description And Specifications; Intended Use; Product Features; Technical Data - Berner BACCS 12V Manual Original

can set alight or explode. Ensure the area is
well ventilated and seek medical attention
should you experience any adverse effects. The
vapours may irritate the respiratory system.
Do not open the battery. There is a risk of
u
short-circuiting.
The battery can be damaged by pointed ob-
u
jects such as nails or screwdrivers or by
force applied externally. An internal short cir-
cuit may occur, causing the battery to burn,
smoke, explode or overheat.
Only use the battery with products from the
u
manufacturer. This is the only way in which
you can protect the battery against dangerous
overload.
Protect the battery against heat, e.g.
against continuous intense sunlight,
fire, water and moisture. There is a
risk of explosion.
Always wait until the power tool has come to
u
a complete stop before placing it down. The
application tool can jam and cause you to lose
control of the power tool.
Product Description and
Specifications
English
Read all the safety and general in-
structions. Failure to observe the
safety and general instructions may
result in electric shock, fire and/or ser-
ious injury.
Please observe the illustrations at the beginning
of this operating manual.

Intended use

English
The power tool is intended for making straight
cuts in wood with and against the grain and mitre
cuts in wood while resting firmly against the work-
piece.

Product features

English
The numbering of the product features refers to
the diagram of the power tool on the graphics
page.
(1) Battery
(2) Battery release button
(3) Lock-off button for on/off switch
(4) On/off switch
(5) Hex key
(6) Spindle lock button
(7) Base plate
(8) Fastening screw for parallel guide
(9) Scale for mitre/bevel angles
1 609 92A 4RZ • 11.12.18
(10) Wing bolt for mitre/bevel angle preselection
(11) Cut mark 45°
(12) Cut mark 0°
(13) Protective guard
(14) Handle (insulated gripping surface)
(15) Battery charge indicator
(16) Temperature monitoring/overload protec-
tion indicator
(17) Wing bolt for preselecting the cutting depth
(18) Cutting depth scale
(19) Adjusting lever for retracting blade guard
(20) Saw spindle
(21) Retracting blade guard
(22) Mounting flange
(23) Circular saw blade
(24) Clamping flange
(25) Clamping bolt
(26) "PowerLight" lamp
(27) Reference mark for mitre angle setting
(28) Fastening screw for dust extraction ad-
apter A)
(29) Dust extraction adapter
(30) Dust extraction hose A)
(31) Reference mark for cutting depth setting
(32) Parallel guide/guide rail adapter
(33) Pair of screw clamps
(34) Guide rail A)
A) Accessories shown or described are not included
with the product as standard. You can find the com-
plete selection of accessories in our accessories
range.

Technical data

English
Hand-held circular saw
Article number
Rated voltage
No-load speed
Max. cutting depth
– at a 0° mitre/bevel angle
– at a 45° mitre/bevel
angle
Spindle lock
Base plate dimensions
Max. saw blade diameter
Min. saw blade diameter
Max. base blade thickness
Max. tooth thickness/offset
Min. tooth thickness/offset
Locating bore
A)
A)
A)
BACCS 12V
343 775
V 12
rpm 1400
mm 26.5
mm 17.0
●
mm 167 x 88
mm 85
mm 85
mm 0.7
mm 1.1
mm 1.0
mm 15
English | 19