Gardebruk Deuba ASX900 Manual Del Usuario página 30

30
Chainsaw head
1.Loosen the sword nut cap (15 (black)) and open the cover.
2.Now insert the chain and the saw blade as shown in the pictures below. Make sure
that the chain is inserted in the right direction! (See picture/device/saw blade)
3.After you have inserted the chain and brought the saw blade into the correct
position, put on the cover and turn the sword nut cap (15(black)) slightly closed.
Then tighten the chain with the chain tension wheel (14(orange)). Make sure that the
chain is not tensioned too tightly or too loosely. When the chain is optimally tensioned,
you can easily pull out the chain with 2 fingertips and immediately switch back into the
saw blade when you release it. Wear safety gloves!
Then tighten the sword nut cap (15(black)).
2.
1.
15
3.
14
15
Connect the telescopic rod to the chainsaw head
1.Screw the screw sleeve onto the telescopic rod and pull it out a little. Tighten the
screws again.
2.Now connect the saw head with the rod. Pay attention to the marking on the saw
head and bar. Finally tighten the screw sleeve.
www.DeubaXXL.de